[ad_1]
First, prepare yourself a clean working environment. This can be a dining room table, a removable-all-enough table for your wallet to lie on its side, and a room full of all your belongings. You also need a Phillips header that can match your straps. When you put these organs together, make sure that releasing any construction and work without stones like a wooden table. Or you can simply attach the box to the top of the cardboard that comes in.
Most of the products you purchase come with instructions on how to use them; keep them close. We’ll start with the box, so open the instruction manual on the preparation page. It can be scary — there’s a lot to see — but think of it all as a giant Lego team. Each piece fits. For the motherboard, your first task will be under your CPU.
Installing Your CPU
Depending on the type of CPU you purchased (Intel or AMD), the device has a few prongs on one side (do not touch) or a gold connection on one side (do not touch). Seriously, do not touch your chip side. Oil from your hands can damage the joints, or you can twist the pin. One by one your processor is just like an expensive silicon hunk.
Having your own processor is easy. First, review your mother’s board instructions and make sure you’ve turned on the socket processor. It will be a large large one with small holes (or connectors), with a lever or button on the side. Your motherboard will tell you exactly how to open a socket so you can install your processor without any problems.
Once you have verified that it is open and ready, simply find your processor’s guide with a small gold clip and place it with the same label on the cover of your boardboard. Avoid the project slowly, then slowly fold the latch or closing method. You do not have to fight. If you have to press hard, double check that the processor is properly configured.
Then, you need yours heated pipe. A small plastic syllable goo plastic is the most important part of the next phase. Now that your processor is seated, look at the shiny cloth in the center. Only then will your temperature be. Your processor came in with a heat, and on one side, you’ll see a brass circle. You’re putting ashes on top of the processor after using a hot paste, and a silicone square and a well-fitting copper circle.
Carefully squeeze a thin ball (no larger than the pea) of the oil paste in the center of the silicon on your processor. You will want it as close as you can.
Now place your cooler and straps around your processor, and slow down a bit. You’re breaking a hot paste, and the goal here is to make a small portion of the back of your processor. It’s fine if it comes out a bit, but if it comes out and on the edge of the processor, you use it a lot. Take isopropyl alcohol, dab on an empty towel, and wipe the processor with a fork. Wait until it is completely dry and try again.
If it looks good, avoid overheating. Go back to your motherboard tutorial to find the right place next to the processor socket to plug in your deep cool fan. It should be very close to your processor bag. When you find it, sign-in thanks, you just installed the CPU. This was the hardest part, and it was it’s over, good job.
Setting Your Storage and Memory
Remembering is probably the easiest thing to set up. Do you see the small hardware that is close to the CPU? Write down your RAM sticks and put them inside, starting at the top left. They will settle down when you are comfortable. If you have two sticks of RAM, make sure you skip the partition between them. Your video book should say where you can use it.
[ad_2]
Source link
